I53 Injector

Previous 5 / 5 Next

I53 Injector  Chemical Decap Failure Analysis I53 Injector  Chemical Decap Failure Analysis

The solution to silver wire decapsulation
The I53 Injector is used to introduce low volumes of a solution into the acid stream of Elite Etch decapsulators. This solution is designed to create a more effective etching process and to prevent metal loss with samples that have silver alloy wires. The system is compatible with other custom corrosion inhibitors which can be formulated for other wire systems.

Product Information

The I53 Injector contains a 250 ml source bottle with double containment and leak detection. A single, small diameter, PTFE tube transfers the solution to the Elite Etch system. A junction block is installed between the pump and heat exchanger of the Elite Etch and injects the solution into the acid stream. All components are made of acid resistant PTFE, PCTFE, or borosilicate glass.
The injection of the inhibitor is initiated by selecting the appropriate operation recipe. The programming screen has a selection of the ratio with a range of 20:1 to 40:1, acid to injector solution. The injection ratio applies to both etching and rinse. The syringe contains approximately 5 ml for a continuous dosage of solution for bond wire preservation.
When an I53 solution injection mode is selected from the handheld, a priming cycle is initiated. This cycle fills the syringe pump and the tubing to the junction block. This cycle purges any excess solution to the waste bottle and prepares for etching with corrosion inhibiting solutions.
On an existing Elite Etch system, the I53 Injector can quickly be installed using a serial communication cable connected from the I53 to the Elite Etch. The existing handheld is now plugged directly into the I53 and does not require additional software. The only modification to the etcher is the installation of the junction block and the routing of the solution tubing through the bottle box and into the I53.


Dimensions Height: 230 mm (9 in)
Width: 230 mm (9 in)
Depth: 127 mm (5 in)
Weight Approx. 16 kg (35 lb)
Power Source 90 to 250 VAC, 50 to 60 Hz (4 amp)
Syringe Type Hamilton gas tight 5 ml capacity
Resolution 0.1323 μl
Cycle Volume 0.0025 to 0.005 ml programmable
Mix Ratio 20:1 to 40:1
Dispense Accuracy ±3%, ±0.14 μl
Refill Cycle Time 60 second maximum
Source Bottle Size 250 ml
Compatibilities Elite Etch 7000
Elite Etch Cu 7100
Elite Etch Cu ESD 7200
Mega Etch 7300
Warranty most comprehensive and inclusive warranty in industry (ask for full details)

Please leave your enquiry here, we will reply as soon as possible.
Company Name  
Product Interested  
Contact No.*  
*only support gif, jpeg, jpg, png, pdf

Switch to Mobile Version